Stromberg 97 3x2 Progressive Linkage with Kickdown. 5-1/2in. 9246PRO-KD-CHR

Stromberg 97
3x2 Progressive Linkage
5-1/2in.
With Kickdown
Chromed
9246PRO-KD-CHR

Fits Offenhauser 3558 (small block Chevy) 3x2 intake

Fits Edelbrock 5414 & 5418 (small block Chevy) 3x2 intake

Extended center lever with auto-trans kickdown capability

To use with banjo fittings, add 9086K spacers

Extended throttle shafts not required
 

A premium 3×2 progressive carburetor linkage designed for optimum performance and versatility.
Use on intakes with 5-1/2in carb spacing. If in doubt, simply measure your manifold
spacing – throttle shaft to throttle shaft.

Exclusive to Stromberg Speed Parts, this linkage features our ‘Snapback’ throttle return springs which
virtually disappear from view. Special swivels and bolts clamp the rod ends tight, yet still allow full rotation.
The small bolt has a blind hole, allowing you to insert eg, a hex key, to tighten the lock nut.

The extended center lever has a 1⁄4”UNF thread, which accepts the special fixing common to most (eg ‘Lokar®’)
hot rod auto-trans kickdown cable kits. Stromberg KD linkages are designed to work with the Stromberg
Cable Throttle Bracket (9136K).

The tapered rod stops are fully adjustable, with discreet set screw fixings and opposite threaded rod ends
ensure easy adjustment. Just spin the secondary link rod to adjust for the correct lever angles.

The linkage comes pre-assembled, installs in just two simple steps and comes with full instructions.
Click the other tabs for help with installation and tuning.

WARNING! To use this linkage with banjo fuel fittings, you must add our 9086K banjo fitting spacers to
ensure safe clearance between the long lever and the fuel line. Always read the instructions before installation.

WARNING! Always check that your vehicle’s automatic transmission and kickdown cable are compatible
with the Stromberg KD linkage. Different transmissions have specific kickdown requirements and incorrect
set-up can result in transmission damage.