Speedway Universal Weld-On Rear Panhard Bar Track Rod Kit 916-49022

Universal Fit, Adjustable, 22.5" Tube Length, Steel

• Universal Panhard bar kit works with any parallel mount multi-link suspension
• Required for coil spring and coil-over rear suspensions to control lateral (side to side) axle movement
• Complete kit includes 7/8" DOM steel Panhard rod, 5/8" rod ends, weld-on brackets and hardware
• Features a 22.5" long bar made from .156" wall thickness steel tubing
• 5/16" and 3/8" weld-on mounting plates made from A36 steel plate for strength

• Works on most any chassis and rear axle configuration
• Controls rear axle laterally and works in conjunction with multi-link suspensions
• 25-1/2-inch OAL Panhard bar measured center-to-center of rod ends
• Panhard rod made from 7/8-inch DOM steel tubing and uses 5/8-inch rod ends
• Rod ends are left hand and right hand threaded to allow adjustment on car
• Frame and axle housing brackets made from A36 steel plate

Control Your Rear Axle’s Lateral Movement with This Easy to Install Panhard Bar Kit

Factory suspensions, including leaf spring setups and triangulated four links provide some lateral control of the rear axle housing,
but this control often comes at the cost of binding or suspension limitations.
When upgrading these suspensions to such setups as a parallel multi-link with coilovers
for additional control of your rear axle’s placement and the minimization of pinion angle change under acceleration,
you will find that these systems do not have a way to control lateral axle movement when cornering.
That is where the Panhard bar comes into play.

The Panhard bar has been used in various suspension designs for over 100 years and is quite simple in design and function.
The Panhard bar mounts between the chassis and the rear axle assembly,
allowing the axle freedom to move up and down through normal suspension articulation without the axle moving laterally.
Factory implementation of a Panhard bar has been used by all the major automotive manufacturers over the years,
but these are fixed length bars where no Panhard bar adjustment can be made.
An aftermarket universal Panhard bar kit is adjustable, which aids in centering the axle in the body.
If there is any detriment to a Panhard bar (besides being a tad difficult to route tailpipes around)
is that as the axle moves up and down the Panhard bar causes the axle to move in a small arc,
changing the axle location laterally as the suspension moves.
This is only a real concern if you have very tight tire to quarter panel gaps or extremely low ride height.

Heavy Duty Steel Construction Compliments Your Aftermarket Rear Suspension

Starting with a 22-1/2-inch long and 7/8-inch diameter DOM steel tube with .156-inch wall thickness for our Panhard rod,
we thread the steel tube for a pair of 5/8-18 rod ends with left hand and right hand threads.
This allows Panhard bar adjustment right on the vehicle with only having to loosen the jam nuts for adjustment.
The included weld-on frame bracket is made from 5/16-inch thick A36 steel plate,
as is the axle mounting bracket, which uses slightly thicker 3/8-inch steel.
We include attaching hardware for the Panhard bar’s rod ends to the frame and axle brackets along with full instructions.
No matter what type of parallel link rear suspension system you’re planning,
our universal Panhard bar kit will help keep your rear axle properly located.

Specs

• 25.5" overall length of Panhard bar center-to-center of rod ends
• 5/8" hardware included to mount Panhard bar to frame and axle brackets
• Axle mount Panhard bar bracket is 5-1/4" overall length with 4-5/8" center of bolt hole to bottom of bracket
• Frame mount Panhard bar bracket is 2-9/16" overall length with 2" center of bolt hole to bottom of bracket